CDCP Dumps with Practice Exam Questions Answers

A fire extinguisher in the data centre that is classed as ABC is not suitable, because it contains dry chemical powder that can damage the ICT equipment and the data. ABC fire extinguishers are designed to fight Class A, B, and C fires, which are fueled by combustible materials, flammable liquids or gases, and electrical equipment, respectively. However, the dry chemical powder can leave a corrosive residue on the ICT equipment, which can cause short circuits, data loss, or malfunction. Moreover, the dry chemical powder can be difficult to clean, especially from the small spaces and crevices of the ICT equipment. Therefore, ABC fire extinguishers are not recommended for data centres, and should be replaced with more suitable fire extinguishers, such as clean agent fire extinguishers, which use gas or liquid that does not leave any residue or harm the ICT equipment.

Sprinkler heads used in computer rooms activate at 57 °C (135 °F), which is the standard temperature rating for ordinary sprinklers. This is the temperature at which the heat-sensitive element of the sprinkler head, such as a glass bulb or a fusible link, breaks or melts, allowing water to flow from the sprinkler. Sprinkler heads are designed to activate only when exposed to a fire, not to ambient temperature fluctuations. Therefore, sprinkler heads should be installed at a sufficient distance from the heat sources, such as servers, racks, or ducts, to avoid accidental activation. Sprinkler heads should also be selected and installed in accordance with the relevant standards and codes, such as NFPA 13 and NFPA 75.

According to the CDCP Preparation Guide1, magnetic fields of the type ‘H’ or ‘B’ are created when an electric current flows through a conductor, such as a wire or a coil. The magnetic field strength ‘H’ is proportional to the current ‘I’ and the number of turns ‘N’ of the coil, and inversely proportional to the length ‘l’ of the coil. The magnetic flux density ‘B’ is proportional to the magnetic field strength ‘H’ and the permeability ‘μ’ of the medium in which the magnetic field exists. The greater the current, the stronger the magnetic field and the magnetic flux density. The relationship between ‘H’, ‘B’, ‘I’, ‘N’, ‘l’, and ‘μ’ can be expressed by the following equations:

H = N I / l

B = μ H

Optical fiber cables are composed of a core, a cladding, and a coating. The core is the central part of the fiber that carries the light signal. The cladding is the layer surrounding the core that reflects the light back into the core and prevents signal loss. The coating is the protective layer that covers the cladding and provides mechanical strength and environmental protection. The specifications of an optical fiber cable indicate the dimensions of the core and the cladding in microns (μm), which are one millionth of a meter. For example, a 50/125 μm cable has a core diameter of 50 μm and a cladding diameter of 125 μm. The coating diameter is usually 250 μm, but it is not part of the specifications.

According to the CDCP® Preparation Guide, Class A fires involve ordinary combustible materials such as paper, wood and cloth. These materials leave behind ash or embers when they burn. Class A fires can be extinguished by water or other cooling agents that reduce the temperature of the fuel below its ignition point.