Summer Sale - Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: dpt65

4A0-111 Questions and Answers

Note! Following 4A0-111 Exam is Retired now. Please select the alternative replacement for your Exam Certification.

4A0-111 Questions and Answers

Question # 6

When using voyager what will make permanent changes after a reboot (Choose

one)

A.

Clicking apply

B.

Clicking apply and then save

C.

Saving changes from advanced fw config

D.

Clicking apply and rebooting the NAP

Full Access
Question # 7

A policy is configured to redistribute four active static routes into ISIS. No ISIS route is received on the far end, what is the cause of the problem?

A.

Action accept?has to be configured for entry 10

B.

Default-action has to be configured as accept

C.

Import policy should be configured under ISIS instead of export policy

D.

Within entry 10, to protocol isis has to be configured

E.

A prefix list has to be configured to filter the routes

Full Access
Question # 8

You have a number of Nokia appliances routing traffic with OSPF.

They advertise the networks 192.168.1.0/24 and 192.168.2.0/24. The network

interface for 192.168.2.0 becomes unreachable. Which of the following statements is

true (Choose all that apply)

A.

The network 192.168.2.0 is still advertised until it becomes reachable

B.

It will take 120 seconds for the network to no long be advertised

C.

Uses Link state Advertisements to inform of changes

D.

The network 192.168.2.0 will no longer be advertised

Full Access
Question # 9

VPRN 300 is configured between Node 3 and Node 4. Node 4 receives VPN routes from Node 3 and imports them into the VRF. The entire route-table is displayed below for VPRN 300 on Node 4. When attempting a ping from VPRN 300 on Node 4 to 30.1.1.1 the ping fails. A ping from Node 3 within VPRN 300 to 30.1.1.1 is successful. What is the cause of the problem?

A.

No local interface existed in VPRN 300 route-table on Node 4

B.

Syntax problem in the ping command

C.

Prefix 30.1.1.1 does not exist on the far-end

D.

Source address has to be specified in the ping command

E.

Next-hop address has to be specified in the ping command

Full Access
Question # 10

Which of the following regarding "well-known discretionary'' BGP attributes is TRUE?

A.

They must be recognized by all peers and included in all BGP updates.

B.

They are discarded if not recognized by the recipient.

C.

They must be recognized by all peers and optionally included in BGP updates.

D.

The receiving router sends a notification if a well-known discretionary attribute is not present in an update.

Full Access
Question # 11

At what layer does High Availability provide resiliency (Choose one)

A.

Layer 2

B.

Layer 3

C.

Layer 4

D.

Layer 7

Full Access
Question # 12

From what range are 16-bit private AS numbers selected?

A.

64496 – 64511

B.

1 – 56319

C.

64512-65534

D.

64513-65535

E.

There are no defined private AS numbers; there are only private IP addresses.

Full Access
Question # 13

Based on the configuration below, which statement best describes the reason why VPLS 101 is not up on all three nodes.

A.

Service VC id has to match on all three nodes

B.

SDP id has to match on all three nodes

C.

STP has to be enabled on all three nodes

D.

No SAP is configured on Node-2

E.

Mesh-sdp has to be used on all three nodes

Full Access
Question # 14

what type of routes does OSPF use (choose all that apply);

A.

Inter area

B.

Intra area

C.

Infra area

D.

Type1 External

E.

Type2 External

Full Access
Question # 15

You swap the interfaces of LAN and DMZ both running DHCP. Ip assignments are

also swapped. Choose the most correct Answer:.

A.

No further action is required. The IP's have been swapped and IPSO retains the pool

of addresses based on this.

B.

IPSO reserves the IP pool and this must be reconfigured

C.

You must delete the IP address pools and create new ones based on the new interfaces

D.

Pools are created in layer 3, the changes have taken place at layer 2 and no further

action is required

Full Access
Question # 16

Where does checkpoint store its state tables (Choose One)

A.

Checkpoint stores this in /etc/syncron.conf

B.

Checkpoint uses the file $FWDIR/conf/sync.conf as its state table

C.

Within the hosts file /etc/hosts

Full Access
Question # 17

Which command is used to view alarms of all severity levels on theNokia7x50?

A.

Show log log-id 99

B.

Show alarm

C.

Show log filter-id 1

D.

Show log log-id 100

E.

Show log 99

Full Access
Question # 18

Host file should contain what entries

A.

An entry for the loopback address to stop routing loops

B.

The local machine so as to be able to resolve its own external IP and for licensing

C.

A listing all interfaces on the machine

D.

List of all users who require access to the machine

Full Access