H12-322 Questions and Answers

Usually, what is the attenuation of 2.4GHz at 10 meters?

What are the precautions in using the WLAN Survery PAD survey tool for pre-sales network planning?

In the backhaul scenario where the AP6510DN is connected to the AT815SN in point-to-point, the return distance is about 100m. The six AT815SNs are distributed in a length of 60 meters and wide.

Within 60 meters, the equipment is installed at the same height and has a line of sight.

When the upstream bandwidth requires 10 Mbps and there is no EIRP limit, which of the following antennas can be selected?

In a school dormitory scenario, WLAN needs to be deployed. The customer proposes to maximize the bandwidth. Which of the following methods can best meet the needs of customers?

If you use a layered network design method in enterprise network design, what are the three levels of network?

What is the default priority of VRRP?

Which of the following options is not a scene-aware element of user access control in high-density?

Which of the following options are the design principles for WLAN outdoor sites?

What are the two most important inputs in the WLAN pre-sales survey?

During the WLAN survey, the engineer needs to determine the coverage target requested by the customer. The coverage currently includes: the main coverage target and the secondary coverage target.

And special targets, the field strength within the main coverage target needs to reach between -65dBm ~ -85dBm.

A company deploys an outdoor WLAN. The AP device is Huawei's outdoor AP6510DN. In order to save costs, engineers plan to pass AC6605

Powering the AP directly. The AC6605 only has a 500 W PoE power module. The AC6605 requires 120 W for normal operation.

Rate, then how many AP6510DN can the AC6605 supply?

In the coverage area, only the area where the field strength is required is selected (B), and the area with the specified number of bandwidth requirements is selected (A), and there is no concern whether there is a signal. Area selection?

In the WDS and Mesh networks, in order to avoid interference of other signals on the backbone link, the 2.4 GHz band is generally used as the frequency band of the network backhaul.

A park needs to achieve full coverage of WLAN. The length and width of the park is 100m×100m. There are clamps that can be installed in the middle. The capacity requirements are lower. Which of the following?

Which antenna is best for the above scenario?

The following is true about the AP installation location?

Which two APs below support the 802.11ac standard?

What is the correct WLAN network planning process?

Which of the following channels and adjacent channels have adjacent channel interference?

In a certain room subsystem, using the AP9330DN, each incoming antenna can be set to a different channel to avoid co-channel interference.

In the active/standby dual-link scenario, the default CAPWAP heartbeat is set to?

In any country, the use of directional antennas can significantly increase the coverage area of ​​the WLAN.

The following is the correct description of the AC deployment method?

For WLAN outdoor coverage planning, what is the recommended coverage radius when using an external 2.4G 3dBi omnidirectional antenna?

Which of the following is best for deploying WLANs using indoor distribution?

When using two ACs for VRRP networking, in order to assign the correct address and gateway to the AP, which of the following address allocation schemes cannot be used?

The United States complies with the FCC standard. In an outdoor road scenario, an AP8030DN uses channels 1 and 149 for road coverage, and a single spatial stream terminal is connected.

In the case of considering the MIMO gain, regardless of the feeder loss, what is the maximum transmit power of the AP 2.4 GHz and 5 GHz, respectively?

The AC is configured as follows. How long does it take to open RTS/CTS when the length of the packet exchanged between the terminal and the AP?

[AC6605-wlan-view] radio-2g-profile name default

[AC6605-wlan-radio-2g-prof-default] rts-cts-mode rts-cts

[AC6605-wlan-radio-2g-prof-default] rts-cts threshold 1500

Users use the WLAN Tester 2.0 tool to perform the survey and must load the network card before starting the survey.

Regarding the NIC loading, the following statement is correct?

Which of the following devices has an internal antenna?

Which of the following outdoor APs supports dual 5G deployment scenarios?

Which of the following are typical of AP coverage in high-density venues?

When the AD9430DN-24 is deployed in the project, when the remote access unit R240D is installed and exceeds the PoE power supply distance, the switch can be expanded.

exhibition.

What is wrong about the description of antenna azimuth and downtilt below?

Which of the following devices can be used as PDs?

Which of the following options are characteristic of the business needs of high-density venues?

Directional antennas have a stronger gain in signal strength in horizontal and vertical lobes, and no signal outside the lobes. So it is recommended to use high gain

Directional antennas to increase outdoor AP coverage distance.

The following is a statement about the combination of the WLAN room subsystem and the existing operator room system. What is wrong?