Summer Sale - Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: dpt65

H11-811 Questions and Answers

Note! Following H11-811 Exam is Retired now. Please select the alternative replacement for your Exam Certification.

H11-811 Questions and Answers

Question # 6

In U1900 series unified gateway, which of the following is CORRECT concerning number conversion priority?

A.

Number change < Number mapping < Long and short numbers

B.

Number mapping < Long and short numbers < Number change

C.

Number mapping < Number change < Long and short numbers

D.

Long and short numbers < Number change < Number mapping

Full Access
Question # 7

The U1981 unified gateway provides a web management system to enable maintenance personnel to perform (). (Multiple Choice)

A.

board, user and trunk configuration

B.

device upgrade

C.

signaling tracking

D.

board status and resource management

Full Access
Question # 8

Which of the following statements is CORRECT about FXO and FXS ports?

A.

FXO port on the PBX connects to the POTS phone.

B.

An FXS port can connect to another FXS port.

C.

An office has deployed an IAD to provide call services for 10 employees. In this scenario, the FXS port on the IAD can be used for PSTN outgoing calls.

D.

The phone line of a POTS phone connects to an FXO port.

Full Access
Question # 9

Which of the following configuration steps does not belong to the PIN-Code call barring configuration process?

A.

Enable the PIN-Code call barring service.

B.

Configure the PIN-Code account and password.

C.

Assign the PIN-Code call barring service rights to a user.

D.

Enable the PIN-Code service for IP phones.

E.

Modify the call attribute.

Full Access
Question # 10

A SIP trunk is an IP-based packet trunk. If the SIP trunk uses SIP signaling as the signaling control protocol, only UDP can be used as the transport layer protocol.

A.

TRUE

B.

FALSE

Full Access
Question # 11

Fax machines can use PSTN to transmit signals. Fax machines can be classified into group 1, group 2, group 3, and group 4 fax machines by transmission speed and modulation mode.

A.

TRUE

B.

FALSE

Full Access
Question # 12

Which of the following statements are CORRECT about the instant conference service in U1900? (Multiple Choice)

A.

All the internal users can be invited.

B.

The instant conference service is enabled for all uses by default.

C.

Users with Normal or higher privilege has the instant conference service enabled by default.

D.

Users with Advanced or higher privilege has the instant conference service enabled by default.

Full Access
Question # 13

A () network is suitable for an enterprise with no more than 20,000 users that does not have branches or has branches that do not require bcal regeneration.

A.

Single -node

B.

Centralized call management

C.

Distributed call management (peer-to-peer mode)

D.

Distributed call management (aggregation mode)

Full Access
Question # 14

Which of the following statements are CORRECT? (Multiple Choice)

A.

The AT0 trunk is often used to implement DDI features.

B.

The SS7 trunk can be an ISUP trunk or a TUP trunk.

C.

The PRA can be configured at the user side or at the network side.

D.

SIP is a transport-layer control (signaling) protocol.

Full Access
Question # 15

eSight, DNS server, and DHCP server have been deployed in the live network of an enterprise. If 200 IP phones are added, which of the following methods cannot be used to configure the TR069 parameter for the IP phones in batches?

A.

On the DNS server, configure the mapping between the domain name and the IP address of eSight.

B.

Deliver the TR069 parameter to the IP phones in batches through the DHCP Option246 field

C.

Use access scan.

D.

Perform configurations on the web configuration page of the IP phones.

Full Access
Question # 16

A user can place calls but cannot receive calls. What are the possible causes? (Multiple Choice)

A.

The user has enabled the do not disturb (DND) service.

B.

The user has configured the call forwarding unconditional (CFU) service.

C.

The outgoing prefix is not configured.

D.

The user number is not configured.

Full Access
Question # 17

Through the eSight version file management function, version files of IP phones can be updated and upgraded in batches.

A.

TRUE

B.

FALSE

Full Access
Question # 18

Which of the following statements is CORRECT about call rights for U1900?

A.

U1900 supports four default call rights. Users can customize call rights.

B.

Users with the default service level have national call right for outgoing calls.

C.

Users assigned the national call rights only have national call rights for outgoing calls (except for intra and local call).

D.

Users assigned the international call rights have intra, local, and international call rights for outgoing calls.

Full Access
Question # 19

The U1981 unified gateway supports () PRA trunk at most.

A.

4

B.

8

C.

12

D.

24

Full Access
Question # 20

Which of the following indicates a server error in SIP protocol?

A.

3xx

B.

4xx

C.

5xx

D.

6xx

Full Access
Question # 21

The HTTP server can deliver the same policy file to eSpace IP phones of the same model to upgrade the IP phones in batches.

A.

TRUE

B.

FALSE

Full Access
Question # 22

Which of the following does not bebng to the U1900 cabling specifications?

A.

The PGND cable is grounded based on the nearby principle, and is properly connected to the ground bar.

B.

The length of the PGND cable does not exceed 45 cm. The PGND cable shall be as short as possible, and coiling is forbidden. If the length of the PGND cable exceeds 45 cm, relocate the ground bar.

C.

The PGND cable shall not be in parallel or twisted with signal cables.

D.

Signal and power cables are separated, and analog and digital signal cables are routed together.

Full Access
Question # 23

To enable the automatic number allocation function, set the BIN channel parameters of the U1900 on eSight, among which the password must be set to the ()?

A.

Password to access the View mode of the U1900

B.

Password to access the Config mode of the U1900

C.

Password of the Super mode of the U1900

D.

All of the above

Full Access
Question # 24

Perform the following configurations on the U1960:

1. Create an office route selection code by setting Office route selection code to 8, Office route selection policy to None, and Failure Processing Index to None.

2. Create an office route by setting Office route number to 8 and Office route selection code to 8.

3. Create another office route by setting Office route number to 9 and Office route selection code to 8.

4. Create a prefix by setting Prefix to 9, Service type to Basic service, Call property to Local call. Called number change to None, and Office route selection code to 8.

According to the preceding configurations, which of the following statements is CORRECT? ()

A.

When a user views the office route mapping the office route selection code 8 on the U1960, only office route 9 exists, and office route 8 is replaced by office route 9.

B.

When a user on the U1960 dials prefix 9 to make an outgoing call, office route 9 is preferred to route the call.

C.

When a user on the U1960 dials prefix 9 to make an outgoing call, office route 8 is preferred to route the call.

D.

When a user on the U1960 dials prefix 9 to make an outgoing call, office route 9 is preferred to route the call. When the trunk for office route 9 is faulty, the call will be rejected.

Full Access
Question # 25

During the U1900 operation, the MTU board supports hot swap.

A.

TRUE

B.

FALSE

Full Access
Question # 26

When a user dials the VMS unified access prefix to retrieve messages, the user needs to enter authentication information, for example, the password.

A.

TRUE

B.

FALSE

Full Access
Question # 27

Which of the following statements are CORRECT about the narrowband trunk? (Multiple Choice)

A.

The ATO is a type of narrowband trunk.

B.

The SS7 can be configured at the user side or at the network side.

C.

The PRA uses the 30B+D structure.

D.

The R2 refers to CNo.1.

Full Access
Question # 28

About the voice mailbox service, which of the following statements are correct? (Multiple Choice)

A.

All the U1900 series gateway have built-in voice mail box.

B.

User can transfer the VMS message on the IP phone

C.

The U1980 needs to work with the UMS server to implement the voice mailbox function.

D.

All the U1900 series gateway can work with the UMS server to implement the voice mailbox function.

Full Access
Question # 29

() is not the method to locate the common fault in IFT system?

A.

Checking Alarm

B.

Log Analysis

C.

Signaling Tracking

D.

Replacing Board

Full Access
Question # 30

When adding a SIP phone on U1900, you must ensure that ().

A.

The configured EID must be the same as the phone number.

B.

The EID can be digits only.

C.

The phone number can be digits or a combination of the asterisk (*) and digits.

D.

The EID is not required.

Full Access
Question # 31

Which of the following upgrade methods can be supported by IAD? (Multiple Choice)

A.

Web manual upgrade

B.

CLI + FTP manual upgrade

C.

Upgrade in the eSight

D.

LMT

Full Access
Question # 32

Which of the following information is required when you apply for a license for the U1981? (Multiple Choice)

A.

MAC address

B.

ESN

C.

Model

D.

Version number

Full Access
Question # 33

IP phones can adapt to different networking modes, including UC2.X, UC2.0, IMS+UC, and IMS. Therefore, the networking mode needs to be set based on the actual networking. The default networking mode is UC2.X.

A.

TRUE

B.

FALSE

Full Access
Question # 34

In the U1900 connecting to PSTN with the El trunk, the Tx and Rx indicators are off but the call service still fails. To locate the fault, which of the following operations are required? (Multiple Choice)

A.

Perform the CRC check.

B.

Check the position parameter.

C.

Check the clock source.

D.

Check the El cable.

Full Access
Question # 35

IP phones can obtain IP addresses through the DHCP server to access the IP network.

A.

TRUE

B.

FALSE

Full Access