Labour Day - Special 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 70dumps

599-01 Questions and Answers

Question # 6

-- Exhibit –

-- Exhibit --

Refer to the exhibit. What should be used for the recommended cables between the Clustered Granite Cores on eth0_2 and eth0_3?

A.

GigE straight-through cables

B.

GigE crossover cables

C.

This is not a valid design, for clustered Granite Cores

D.

Fiber cables only

Full Access
Question # 7

What are the two steps needed for peer replication configuration? (Select 2)

A.

Configure role, password, and secondary Whitewater IP on the primary Whitewater appliance.

B.

Configure role, password, and megastore ID on the primary Whitewater appliance.

C.

Configure role, password, and primary Whitewater IP on the secondary Whitewater appliance.

D.

Configure role, password, and megastore ID on the secondary Whitewater appliance.

Full Access
Question # 8

When configuring your backup software to utilize a Whitewater appliance, what possible target must the backup software be able to write to? (Select 2)

A.

Virtual tape library

B.

NFS

C.

CIFS

D.

iSCSI target

E.

Physical tape library

Full Access
Question # 9

On a Granite Edge, which is used to store transient data, per example, no requirement to replicate back to the data center?

A.

ESXi partition

B.

VSP partition

C.

Local LUN

D.

Pinned LUN

Full Access
Question # 10

What RAID protection level is supported on Whitewater appliance?

A.

RAID-1

B.

RAID-5

C.

RAID-6

D.

RAID-10

Full Access
Question # 11

Granite high availability is typically combined with what other high availability services or protocols? (Select 2)

A.

MPIO

B.

Redundant WAN links

C.

EtherChannel

D.

HSRP

E.

PBR

Full Access
Question # 12

If performing a disaster recovery (DR) test, what commands and in what order do they need to be run?

Full Access