H35-460 Questions and Answers

The gNodeB RF unit can also set the engineering mode.

What are the networking methods between the BBU and the RF unit? (Multiple Choice)

Regarding the DMRS of the PDSCH, what are the correct descriptions of the following? (Multiple Choice)

Only the 60kHz subcarrier bandwidth supports the configuration of extended CPs.

Which of the following does not belong to the BBU board?

Which of the following applications does not belong to the 5G eMBB scenario?

Which functional modules of BTS5900A base station are optional?

In the 5G RAN2.0 version, what is the maximum number of 100MHz 64*64 cells supported by a single BBU900?

AAU/RRU and BBU fronthaul fiber is less than 100 meters, mostly used in CRAN centralized site solutions.

In version 5G RAN 2.0, how many 100MHz NR cells does AAU5613 support?

Log in to the CPE Pro management page, and directly use the "Delete" function to delete the currently activated APN on the "APN Management" management interface

When gNodeB adds NRCELL cell information, it binds the DU unit identifier.

The NR neighboring cell measurement event of the UE adopts B1, and the corresponding RSRP threshold value 35, which is the true level value?

The X2 interface between LTE and NR can be established by configuring the data separately on the LTE side or the NR side

How many 100MHz NR cells does the AAU5613 support in the 17.5G RAN2.0 version?

Regarding DWP, what are the correct descriptions of the following? (Multiple Choice)

The transmitted data in the initial data configuration of gNodeB has a strong coupling relationship with the wireless data.

When gNodeB planning has multiple IP addresses and different next-hop addresses, which of the following routing configurations is more suitable?

Which of the following MML commands are required to add neighbor information across gNodeB?

Which of the following is the protocol layer added to the NR air interface protocol stack?

Before using U2020 remote NR base station commissioning, which of the following tasks must be prepared?

The VLNA group mode of gNodeB can tag different traffic with VLAN tags based on service type.

gNodeB configures cell duplex mode based on band information.

5G RAN side service slice management, which of the following facilities is implemented?

Which of the following parameters is related to the frequency domain position of the PBCH DMRS?

In the 5G network test, what is the recommended test distance between the CPE and the gNB on the terminal side?

The next board supports software reset?