HPE6-A66 Questions and Answers

A university department has a program in video processing and editing. Students in the department use Wi-Fi to interact with the video servers. The editing and processing is done by the students accessing and using the video servers. However, the students must then stream their results, via Wi-Fi to their laptops to verify the results. A network architect has determined that no more than 20 APs will be needed for the Wi-Fi solution. Because of the large amount of bandwidth used during the streaming, the Aruba mobility controller solution will need to support 10 Gbps links.

Which solution would cost-effectively meet this customer's requirements?

A customer is designing a new wired network. The customer requires 50 Gbps uplinks, VSF logical switching, and smart rate port support Which of the following switches would meet these requirements?

NewStellar has a main corporate campus in a business park with two adjacent buildings. Each building has three floors and each floor is 322 x 175 feet (98 x 53 meters) for 56,350 square feet (5,235 square meters) total. The ceiling for each floor is 12 feet (3.6 meters) high with a drop-down ceiling at 10 feet (3 meters). The network architect has given you one floor to analyze, Building 1 Floor 2, shown in the attached exhibit.

This floor has a central main corridor with washrooms, stairs, elevators and supply and network cabinets. There are cubicles around the perimeter of the floor. The central part main corridor's dimensions contain 9,350 square feet (870 square meters). Assuming that wireless coverage is not required in the central area, which square footage (square meter) value should a network architect use when determining the number of APs in a capacity design for each floor?

A network architect needs to design a new wireless solution for a small company The architect estimates that about 150 APs will be required to implement a capacity design. Roaming support is required. Also, the design requires meshing to connect some of the APs to the network.

The customer requires that client state synchronization be provided for real-time failover.

Which solution would most cost-effectively meet these requirements?